Hand punch & die set. Each punch has
a corresponding die. Hand punch manual.
Punches have a small point to aid centering.
18 gauge or ~0.05" metal, maximum thickness.
Die &
Hollow Punches
Last updated on
Wednesday, September 20, 2023 08:59:55 AM
Mountain US Time Zone
HOME
Die Punch Sets, Hollow Punch Sets
Die Punch Sets
Hand punch & die set. Each punch has
a corresponding die.
Hand punch manual.
Punches have a small point to aid centering.
18 gauge or ~0.05" metal, maximum
thickness.
| HAND PUNCH DIES | |||
|
# |
SIZE |
||
| 1 | 3/32" | 0.09375" | 2.4 mm |
| 2 | 1/8" | 0.125" | 3.2 mm |
| 3 | 5/32" | 0.15625" | 4.0mm |
| 4 | 3/16" | 0.1875" | 4.8 mm |
| 5 | 7/32" | 0.21875" | 5.6 mm |
| 6 | 1/4" | 0.25" | 6.4 mm |
| 7 | 9/32" | 0.28125" | 7.1 mm |
A die punch
set having nine different sizes.
Hardened alloy steel; clear plastic guide.
Tolerance is 0.002".
The cutting end has a sharp
edge whereas the striking surface is chamfered.
| DIE PUNCH SET | |||
| # | SIZE | ||
| 1 | 1/8" | 0.125" | 3.2 mm |
| 2 | 3/16" | 0.1875" | 4.8 mm |
| 3 | 1/4" | 0.25" | 6.4 mm |
| 4 | 5/16" | 0.3125" | 7.9 mm |
| 5 | 3/8" | 0.375" | 9.5 mm |
| 6 | 7/16" | 0.4375" | 11.1 mm |
| 7 | 1/2" | 0.5" | 12.7 mm |
| 8 | 5/8" | 0.625" | 15.9 mm |
| 9 | 3/4" | 0.75" | 19.1 mm |
A 1/2" diameter 0.0015"
thick brass shim.
Die punching a 3/4" rubber
washer.
The cardboard protected the surface.
A light tap using a rubber
hammer is all that was needed.
Hollow Punch Sets
Hollow punches that can be easily re-sharpened.
Set on the right has small, interchangeable tips.
Top to bottom:
1/2", 7/16",
3/8",
5/16", 1/4",
3/16", 5/32", 1/8", & 3/32".
Die Punch Sets, Hollow Punch Sets